Tutorials to .com

Tutorials to .com » Website » Freehand » FreeHand ratchet mechanical drawing of the production

FreeHand ratchet mechanical drawing of the production

Print View , by: iSee ,Total views: 7 ,Word Count: 565 ,Date: Wed, 27 May 2009 Time: 2:08 AM

4 in this step we have to draw the perspective of the size of lines, the size of the angle is a line arc. We can see from the interception of a circle, as in the figure below draw a great circle, and then use the freehand tool knife in the toolbox in the great circle size and angle of intersection Department lead click to cut off the arc.

Union Network bitsCN.com China

Union Network bitsCN.com China

5 step great circle has been cut off, but has not yet shown results, we just use the mouse to select the part of great circle and not to open it it. Left and then select the section of arc, the linear change it with the arrow at both ends can form.

6 Finally, the line marking the left side of the angle marked 20 Angulinao cup dark  pain Ω Blattella flash Shu-ping J ? 0 text input tool that a small degree only draw a round circle marked it down to the appropriate the extent of 20 and then moved to the upper right corner of it.

Network Management Forum China bbs.bitsCN.com

7 In this comprehensive example, we use a variety of places before Freehand tool to draw a ratchet parts diagram, it is not the effect of painting than autocad it favorably.

This page is the final steps in this case, is still done in parts to ratchet icon size, previous steps are given, we ratchet up the length of icon size, and now we have to subscript to it on the perspective of size, length size the size of line is a straight line, and the size of the angle size is a circular line, a straight line can be drawn, but Freehand paintings of a certain point of view there is no direct command of the arc, so we have to resolve it by themselves . In fact, the solution is very simple, as long as the first draw a great circle, with the perspective of the size of your hand over the point of intersection pinout size arc section of the line, and then use knife tool to cut this arc, and then the remainder of the arc can be deleted paragraphs.

Network Management Forum China bbs.bitsCN.com


FreeHand Tutorial Articles


Can't Find What You're Looking For?


Rating: Not yet rated

Comments

No comments posted.